1、濟南鋁板http://www.7075lu.com/應存放于干燥通風處，且平放在平整的表面上，切勿踩踏、撞擊，搬運濟南鋁板時應將板的四邊同時抬起，嚴禁推拉、抽取，以免刮傷板面。
Jinan aluminum should be stored in a dry and ventilated place, and flat on a flat surface, do not stampede, impact, handling Jinan aluminum plate edges should be lifted at the same time, non-sliding, extraction, so as not to scratch the

plate surface.

2、濟南鋁板用開槽機或鑼機開槽時，應使用半圓頭式大于90度的銑刀，下刀既不要過深傷及鋁板，也不要過淺使折邊困難，應留有0.2-0.3MM厚塑料芯材連同鋁板一起彎邊，以增加強度和韌性，否則在彎邊時鋁板可能斷裂或漆膜爆裂。
Jinan aluminum with a slot machine or a gong slotting machine should be used when more than 90 degrees button head type cutter, knife too deep hurt neither aluminum nor too shallow hemming difficulties should leave 0.2-0.3 MM thick

plastic core material together with the aluminum flanges together, to increase strength and toughness, otherwise the aluminum film may break or burst during crimping.

3、濟南鋁板彎邊時需用力均勻，一次成型，不要反復彎折，否則鋁板可能斷裂，加工弧形應使用專用彎曲設備加工，徐徐用力，使板材逐步達到所需的曲面。切勿一次彎曲成型。
Jinan aluminum crimping takes force uniform, a shape, do not repeatedly bent aluminum might otherwise break, you should use special curved arc processing equipment, processing, slowly force, so that the sheet gradually achieve the

desired surface. Never once bent shape.

4、濟南鋁板http://www.7075lu.com/同一型號而不同批次的板材可能存在色差，出售和使用不同批次板材時應增加比對色差之程序，無視覺色差時方可在同一平面使用，將同色鋁塑板安裝在同一平面時，流程方向應一致，否則可能造視覺色差。
Jinan aluminum different batches of the same model and color plates that may exist, the sale and use of different batches of the plate should be increased before use of color than the procedure, no visual color difference in the same

plane, the same color aluminum panels will be installed in the same plane , the flow direction should be consistent, otherwise it may create visual color.