1、先接通濟南鋁板http://www.7075lu.com/壓花機的三相電源總開關，然后打開機臺側控制箱上的電源開關，如果有高周開關的，暫時不開，接著開電熱電源開關，此時，真空管和熱模都開始預熱。
Jinan aluminum embossing machine was switched on three-phase power switch, and then turn on the power switch on the machine side of the control box, if there is high-cycle switch, temporarily not open, then open the electric power switch, this time, the vacuum tube and heat mold began to warm up.

2、在濟南鋁板壓花機下模輔上絕緣物，上極端裝上上模，開試模開關，開始調試上下模接合位置，如果下接合不好，就移動下模，如果水平不合，就調較上模的四支柱子。
Jinan aluminum die embossing machine before putting down insulation, installed on the extreme upper die, open tryout switch down to start debugging mode engaged position, if the next engagement is not good, move the lower die, if the level of irregularities, the adjustments four pillars of the child on the mold.

3、濟南鋁板壓花機的模具調好后，調節時間控制器，下降時間即上模運行到壓緊下模的時間，熔接時間即輸出時間，冷卻時間，即固化時間，上述三個時間需靈活應用，并無固定值數 。
Jinan embossing machine aluminum die after a good tune, adjust time controller, fall time that is running on the die to the die clamping time, welding time that the output time, cooling time, that the curing time, the three time to be flexible application There is no fixed number of values.

4、以上操作如已超過10-15分鐘，且溫度也達到所需時，把高周開關打上，開始操作測試。濟南鋁板http://www.7075lu.com/壓花機成品的效果，由溫度、同調功率輸出、壓力、輸出高周時間四方面決定。
The above operation as more than 10-15 minutes, and when you reach the desired temperature, the high-cycle switch marked to begin operational testing. Jinan finished aluminum embossing machine effect, the temperature, the power output of the same tune, pressure, high-output four weeks aspects decision.